Mesh Forwarder

The reassembly timeout between 6LoWPAN fragments in seconds.

Specifies the time-in-queue threshold interval in milliseconds to drop a message.

Define to 1 to enable delay-aware queue management for the send queue.

When enabled device will monitor time-in-queue of messages in the direct tx queue and if the wait time is lager than specified thresholds it may update ECN flag (if message indicates it is ECN-capable) or drop the message.

OPENTHREAD_CONFIG_DELAY_AWARE_QUEUE_MANAGEMENT_FRAG_TAG_ENTRY_LIST_SIZE.

Specifies the number of mesh header fragmentation tag entries in the list for delay-aware queue management.

The list is used to track whether an earlier fragment of same message was dropped by the router and if so the next fragments are also dropped.

OPENTHREAD_CONFIG_DELAY_AWARE_QUEUE_MANAGEMENT_FRAG_TAG_RETAIN_TIME.

Specifies the max retain time in seconds of a mesh header fragmentation tag entry in the list.

The entry in list is used to track whether an earlier fragment of same message was dropped by the router and if so the next fragments are also dropped. The entry is removed once last fragment is processed or after the retain time specified by this config parameter expires.

Specifies the time-in-queue threshold interval in milliseconds to mark ECN on a message if it is ECN-capable or drop the message if not ECN-capable.

Define as 1 for OpenThread to drop a message (and not send any remaining fragments of the message) if all transmit attempts fail for a fragment of the message.

For a direct transmission, a failure occurs after all MAC transmission attempts for a given fragment are unsuccessful. For an indirect transmission, a failure occurs after all data poll triggered transmission attempts for a given fragment fail.

If set to zero (disabled), OpenThread will attempt to send subsequent fragments, whether or not all transmission attempts fail for a given fragment.

Specifies the maximum number of frames in direct tx queue before new direct tx messages are dropped.

If set to zero then the behavior is disabled, i.e., no check is performed on tx queue length.

The number of fragment priority entries.

Define as 1 to enable TX queue time-in-queue statistics collection feature.

When enabled, histogram of the time-in-queue of messages in the transmit queue is collected. The time-in-queue is tracked for direct transmissions only and is measured as the duration from when a message is added to the transmit queue until it is passed to the MAC layer for transmission or dropped.

The histogram data consists of number of bins, each representing a range of time-in-queue values. The bin interval length is specified by the OPENTHREAD_CONFIG_TX_QUEUE_STATISTICS_HISTOGRAM_BIN_INTERVAL configuration, and the maximum tracked interval is given by the OPENTHREAD_CONFIG_TX_QUEUE_STATISTICS_HISTOGRAM_MAX_INTERVAL.

Along with histogram, the maximum observed time-in-queue is also tracked.

Specifies the time-in-queue histogram bin interval in milliseconds when the TX queue time-in-queue statistics collection feature is enabled.

The number of bins is calculated by dividing OPENTHREAD_CONFIG_TX_QUEUE_STATISTICS_HISTOGRAM_MAX_INTERVAL by OPENTHREAD_CONFIG_TX_QUEUE_STATISTICS_HISTOGRAM_BIN_INTERVAL and rounding up to the nearest integer.

Specifies the maximum time-in-queue interval in milliseconds tracked by the histogram when the TX queue time-in-queue statistics collection feature is enabled.

By default the OPENTHREAD_CONFIG_DELAY_AWARE_QUEUE_MANAGEMENT_MARK_ECN_INTERVAL is used which defines the maximum time-in-queue interval after which a non-ECN capable message is dropped by delay-aware queue management feature.