Border Router DUT Setup

Before continuing, we recommend going through the OpenThread Hardware Codelab, which details how to set up your environment and install all tools and software needed to flash the nRF52840 DK board used in this guide.

Build OpenThread

  1. Clone the OpenThread repository, and switch to the Thread Reference 2018-09-26 release commit: 
    git clone https://github.com/openthread/openthread
    cd openthread
    git checkout -b thread-reference-20180926
  2. Install the GNU toolchain and other dependencies: 
    ./script/bootstrap
  3. Build the nRF52840 example. The USB=1 switch enables native USB CDC ACM as a serial transport. 
    make -f examples/Makefile-nRF52840 BORDER_AGENT=1 BORDER_ROUTER=1 COMMISSIONER=1 \
  DHCP6_CLIENT=1 DHCP6_SERVER=1 JOINER=1 MAC_FILTER=1 REFERENCE_DEVICE=1 \
  UDP_FORWARD=1 USB=1

Flash and connect the NCP

OTBR Nordic Connection

See the Flash the nRF52840 and Connect the nRF52840 steps from the Pre-Built NCP Firmware guide for instructions on how to flash the nRF52840 DK board as an NCP and connect it to the Raspberry Pi.

Similar instructions are also found in the OpenThread Hardware Codelab.

Set up the Raspberry Pi

See the Download and install the OS step from the Raspberry Pi 3B (RPi3B) Border Router platform page for instructions on how to install the OS and configure the device.

In addition to the normal RPi3B setup and configuration, install git and some recommended utilities:

sudo apt-get install git screen tcpdump

Set up OpenThread Border Router

  1. Clone the OpenThread Border Router repository, and switch to the Thread Certified 2018-08-19 release commit: 
    git clone https://github.com/openthread/ot-br-posix
    cd ot-br-posix
    git checkout -b thread-br-certified-20180819
  2. Install dependencies: 
    ./script/bootstrap
  3. Compile and install OTBR and wpantund, using the OTBR certification commit for wpantund: 
    WPANTUND_COMMIT=8c189c6 ./script/setup
  4. Open /etc/wpantund.conf and update the UART port for the nRF52840 DK NCP: 
    Config:NCP:SocketPath '/dev/ttyACM0'
  5. Restart the wpantund service: 
    sudo service wpantund restart

The Border Router should now be up and running. See OpenThread Border Router for more information about OTBR.

Previous
Overview
Next
Test Harness Setup